泉州附近有没有服务

156 6698 0000
 Mesh belt
 Net Conveyor
 Net Conveyor
news information
You Are Here: home page  >  news information

What's wrong with mesh belt conveyor card?

Browse: one hundred and seventy-two Editor in charge: admin Release date: 2020-08-05 15:24:55

When the mesh belt conveyor is running in combination with the gear, the close integration between the gear and the mesh belt causes the mesh belt to be jammed during the circulation. In fact, such a thing is quite common, and it will be good after running in.

Mesh belt conveyor generally as long as it is not bolt or direct friction of the body, there will be no mesh belt disconnection problem, so we can maintain and maintain it normally. We often check the wear and motor of the mesh belt. If the mesh belt is loose, we can tighten it through the tensioning module. If the mesh belt is too loose, it will also block the mesh belt, and the mesh belt is not suitable for over tightening, which is easy to deform the mesh belt.

 Real shot of mesh belt conveyor

1. Some inclined blocking blocks can be installed on the conveyor belt to force the transported materials to change their positions, so that the stuck materials are forced to be pulled out of the mesh holes of the mesh belt, especially at the output port of the mesh belt. It may be effective to install some such blocking blocks.

2. Under the conveyor belt, some supporting plates can also be attached to the net belt to force the material to turn over, so as to avoid material jamming

3. If possible, adding "over rolling" in the middle of the mesh belt also forces the material to turn over

 Structure of mesh belt conveyor

The correct installation and debugging of the mesh belt conveyor in the initial operation is of great significance to evaluate the running condition of the conveyor. Generally speaking, the operation of the mesh belt conveyor should be equipped with accurate power first. If the power is small, it will cause vibration or noise, or even cause the motor to burn down under the condition of long-term overload operation, and if the power is high, it will cause waste.

Mesh belt conveyor is an important conveying equipment. When using it, we must find out whether there is any problem and where the problem is, and then find out the solution. Hope that through the above content, can better help everyone.