The mesh belt conveyor has the characteristics of smooth mesh surface, high hardness, strong corrosion resistance, high tensile strength, good air permeability, not easy to deform, not easy to drain, durable, resistant to cutting, collision, oil and water. Therefore, more and more companies use stainless steel mesh belt conveyor. Stainless steel mesh belt is easy to slip in daily use. How to solve this problem?
1. Too fast starting speed causes skidding
At this time, the starting speed of the conveyor should be adjusted to slow down the starting speed, and it can be effectively started after two times of inching.
2. The place where the mesh belt breaks away from the drum
This is mainly due to the slippage caused by insufficient tension, which can be treated by adjusting the tension equipment and increasing the initial tension.
3. Excessive load of mesh belt
At the moment, there are certain benefits of slipping, which can play a maintenance effect on the electricity. If the conveyor is overloaded for a long time, it is likely to cause burning problem. Therefore, it is necessary to have a general understanding of the weight of the load when using the conveyor.
4. The friction between the driving drum and the mesh belt is insufficient
This is mainly due to water on the mesh belt or the environment is wet. The operator can add some rosin powder on the mesh belt to increase the friction between the two. When adding rosin powder, do not add it by hand, but blow it in with blast equipment to avoid accidents.
5. The bearing of tail drum is damaged and does not rotate
This is mainly due to excessive floating and sinking of the tail of stainless steel mesh belt, or failure to timely repair and replace damaged parts. Therefore, when the mesh belt conveyor problems, it is necessary to repair in time to avoid greater losses.